Page 1 of 1

Funtana S .90 3D with Thunder Tiger 120 Pro

PostPosted: Wed May 14, 2014 7:39 pm
by DwayneG
I was having trouble with my Funtana S .90 3D with Thunder Tiger 120 Pro. It was not running very well and getting worse. I took off the cowl and pulled the head. What I found was the head screws were not very tight. And the head gasket was squirting out of the groove. I have since ordered a new gasket kit ($4.50) :dance:

Re: Funtana S .90 3D with Thunder Tiger 120 Pro

PostPosted: Thu May 15, 2014 7:43 pm
by JRgraham
Well I'll be a son ova gun!

Bearings going out on my DLE 20 this week.. So, being Melissa will be wanting that motor to run a long time, I ordered a new set of Boca bearings, Bowman piston ring, and a new true Walbro carb 8-) If all go's right, that thing should be pretty impressive

Re: Funtana S .90 3D with Thunder Tiger 120 Pro

PostPosted: Sat Jun 07, 2014 9:16 am
by JRgraham
Did you get that thing running good again, Dwayne?

Re: Funtana S .90 3D with Thunder Tiger 120 Pro

PostPosted: Sat Jun 07, 2014 10:37 am
by DwayneG
Yes, it is running fine now. I won’t be out for a while. I’m going on vacation for about a month. I’ll be back the first week of July, see you then.